1. Oracle ILOM Protocol Management Reference SNMP and IPMI Firmware Release 5.0.x
  2. Server Management Using IPMI
  3. Managing IPMI Properties in Oracle ILOM
  4. Set the IPMI State and Session Properties (Web)

Set the IPMI State and Session Properties (Web)

Before You Begin

  • The IPMI state property in Oracle ILOM is enabled by default.
  • As of Oracle ILOM firmware v5.0.x, the following IPMI properties are shipped enabled: Service State, and TLS Sessions. The session property for v2.0 is shipped disabled.
  • Admin (a) role privileges are required to change the IPMI state or session properties in Oracle ILOM.

Follow these steps to set the IPMI state and sessions properties using the Oracle ILOM web interface:

  1. Log in to the Oracle ILOM web interface using an account with admin (a) role privileges.
  2. Click ILOM Administration → Management Access > IPMI.

    The IPMI page appears.

  3. In the IPMI page, enable or disable the property check boxes for IPMI State and v2.0 Sessions.

    Note:

    If the IPMI Service State property is disabled, system management information using the IPMItool utility is not accessible.