Setting SPARC Host State Capture
Oracle ILOM provides host state capture properties that enable system administrators to control the type of data captured if fatal errors occur. The captured data is stored in Oracle ILOM and is obtainable when a service snapshot is taken from Oracle ILOM. The host state capture properties are configurable from the Oracle ILOM CLI or web interface. For further details about the host state capture configurable property values, see the following table.
Table 8-16 Host State Capture Properties for SPARC Server
User Interface Configurable Target and User Role:
|
||
---|---|---|
Property | Default | Description |
State Capture on Error (state_capture_on_error=) |
enabled |
enabled | disabled The State Capture on Error property controls whether or not Oracle ILOM collects host state data upon detecting a fatal error on the host SPARC server. CLI Syntax for State Capture on Error: For SPARC single-server SP, type: set /HOST state_capture_on_error=enabled|disabled For SPARC multi-domain server SP, type: set /Servers/PDomains/PDomains_n/HOST state_capture_on_error=enabled|disabled |
State Capture Mode ( |
default |
Note: The State Capture Mode property only applies to SPARC M5, M6 and T5 systems. This property is not available for configuration on SPARC M7, T7, S7, M8, or T8 systems. redstate_scandump | fatal_scandump | default The State Capture Mode property determines the type of data collected when an error occurs.
CLI Syntax for State Capture Mode: For SPARC single-server SP, type: set /HOST state_capture_mode=fatal_scandump|default|redstate_scandump For SPARC multi-domain server SP, type: set /Servers/PDomains/PDomains_n/HOST state_capture_mode=fatal_scandump|default|redstate_scandump |
State Capture Status ( |
read-only |
The State Capture Status property displays the current host capture state. Possible status states include:
|