Enable SP Diagnostics to Run on Newer SPARC Systems (Web)
Before You Begin
-
The Reset and Host control (
r
) role is required to modify the SPARC diagnostic properties in Oracle ILOM on SPARC systems. -
The Steps in this procedure apply to newer SPARC servers such as T7, M7, and later SPARC series servers.
-
Oracle ILOM firmware version 3.2.5.5 or later.
To enable SPARC diagnostics tests to run, do the following:
-
Navigate to the SP Diagnostic properties:
-
Web:
In the Oracle ILOM web interface, click System Management > Diagnostics.
The Diagnostics page appears.
-
CLI
In the CLI, type: cd /SP/diag
-
-
Perform one of the following:
-
Web:
In the Diagnostics page, configure the following properties and click Save.
-
Default Level [Off (default), Min, or Max] — Specify the appropriate diagnostic behavior in the event of a routine server power cycle (power off/on) or a server reset.
Note:
The POST Default Level property does not apply to error-invoked resets or hardware change events.
-
HW Change [Off, Min, or Max (default)] — Specify the appropriate diagnostic behavior in the event of a server power-cord-cycle, server top cover removal, or FRU (field-replaceable unit) replacement.
Note:
A server power-cord-cycle refers to when the power cords are removed, replaced, or when the power is first applied to server.
where: [Off, Min, and Max]
-
Off — Prevent POST from running
-
Min — Run a basic suite of diagnostic tests
-
Max — Run a basic suite of diagnostic tests, plus extensive processor and memory tests.
-
-
CLI:
In the CLI, issue the
set
command to configure the applicable host diagnostic properties:set default_level= [off, min, max] hw_change= [off, min, max]
For further property details, type: help /sp/diag
-