Auditing the Library
Perform an audit, if:
-
This is a new library.
-
One or more modules have been added, removed, or swapped.
-
Cartridges have been manually added or removed through the mailslot.
-
After library configuration settings have changed.
A self-audit of the library occurs when you:
-
Power-on or re-initialize the library.
-
Open and close the mailslot.
After the self-audit is complete, you must update your database using ACSLS.
When this is a new library
A new library must be audited to synchronize the actual contents of the library with the database.
After adding, removing, or swapping modules
After an SL150 module has been added, removed, swapped, or if you are auditing the library for the first time, perform the following steps:
Vary
the SL150 library offline to ACSLS and power down the library.- Perform the library change, such as adding a module.
- Power on or re-initialize the SL150 library.
- Terminate ACSLS (if it is running) by using the following command:
acsss disable
- Run
acsss_config
. - Start up ACSLS by using the following command:
acsss enable
- Perform an
audit
of the SL150 panel(s) affected.
After Manually Adding or Removing Cartridges Through the Mailslot
If you have manually added or removed cartridges from the LSM through the library mailslot, you must synchronize the databases. Perform an audit
as described under query pool.
If you have entered or ejected cartridges from the LSM through the mailslot using the ACSLS cmd_proc
, the database is automatically updated.
After Changing Library Configuration Settings
If you have changed library configuration settings, you should reconfigure ACSLS using acsss_config,
and then audit
the library. You should also reconfigure and audit
the library after changing the number of reserved cells
Follow these steps:
Vary
the SL150 library offline to ACSLS, and power down the library.- Perform the library change.
- Re-initialize the SL150 library.
- Terminate ACSLS (if it is running) by using the following command:
acsss disable
- Run
acsss_config
. - Start up ACSLS by using the following command:
acsss enable
- Perform an
audit
of the SL150 panel(s) affected.