General Command Syntax
This section describes the general syntax of the ACSLS commands. The following sections fully describe each command, including its syntax.
ACSLS commands use the following general syntax:
command type identifier state options
Where:
type identifier
is the ACS component and its identifier; see Component Types and Identifiers for more information.
-
state
is a device state for the
vary
command only. -
options
are command options; see the description of the command you want to run.
Note the following syntax rules:
-
Enter commands in the order shown above (command name, followed by the component and its identifier, the state and any options).
-
This chapter shows commands in lowercase, but you can enter commands in any combination of lowercase and uppercase letters.
-
Underlines show minimum abbreviations for commands and keywords. For example, query server and
q ser
are both valid forms of thequery server
command. -
Ellipses (...) indicate that you can repeat an identifier.
-
Brackets [ ] enclose optional options.