Create Security Officer and Provide Quorum Login

Create the security officer and quorum login that will be used to access the OKM GUI and restore the cluster.

1. To access the following prompts of the QuickStart, make sure you have entered 3 in the last step of Name the KMA.
2. At the prompt, enter the Security Officer's user name and password.

   Note:

   Oracle recommends you specify a new Security Officer name that did not exist in the OKM cluster when the last backup was performed. Enter a temporary restore Security Officer user ID (for example, RestoreSO) instead of the Security Officer user ID that existed before the restore.

   If you specify an existing Security Officer name and provide a different passphrase, the old passphrase is overwritten. If you specify an existing Security Officer name and other roles were added to that user before the last backup was performed, these other roles are no longer assigned to this User.

3. (Optional)— At the prompt, provide the quorum login user ID and password.

   If you choose to define initial quorum user credentials in QuickStart, you can enter a quorum login name and passphrase at this time so that the restore operation from the OKM Manager GUI is set to pending. Quorum members can then use this login and passphrase later to log in to the OKM Manager GUI and enter their credentials to approve the restore (see Restore a Backup).

   If you do not enter a quorum login user ID here, the only user that exists at the end of QuickStart is the Security Officer created above. In this case, all Key Split Credentials must be entered at once for the restore to occur.

4. Proceed to Set Time Information.