SPARC T7-1 or T8-1 Server Installation

This list is an overview of installing the SPARC T7-1 or T8-1 KMA. For complete installation instructions, use the server's Installation Guide.

Refer to the T8-1 Installation Guide at https://docs.oracle.com/cd/E79179_01/html/E80507/index.html.

Refer to the T7-1 Installation Guide at: https://docs.oracle.com/cd/E54976_01/html/E54979/index.html.

1. Acclimate the server to the installation environment. The server should remain in the shipping crate for at least 24 hours.
2. Prepare the KMA and rack for installation. Tasks include:
   • Stabilize a rack
   • Unpack the contents of the shipping crate.
   • Install the rackmount hardware
   • Attach slide rail assemblies to the rack
3. Install the server in the rack using the supplied hardware. Tasks include:
   • Install the server into the slide rail assemblies
   • (Optional) Prepare the cable management assembly (CMA) for installation
   • Attach the CMA to the server, if applicable
   • Verify operation of the slide rails and CMA
4. Connect cables to the KMA:
   • Serial cable to SER MGT port
   • Ethernet cable to the NET MGT post

     Caution:

     Do not apply power until instructed to do so.

     This appliance includes a service processor (SP) that is used to configure and boot the host server. To properly configure the host server and view SP messages, do not apply power to the server until you make the SP and host networking connections.

   • Power cord to the power supplies and to separate power sources

     Do not power on the KMA at this time.

     When you connect the power cords, the SP initializes and the power supply LEDs light. After a few minutes, the SP login prompt displays on the terminal device. At this time, the KMA is not initialized or powered on.

5. Install another KMA, if applicable.

Install the Cryptographic Card in a SPARC T7-1 or T8-1 Server

Install the optional nShield Solo XC or Solo+ card into slot 5 of the KMA.

1. To access the slot to install the cryptographic card, follow the procedures in the server's service manual regarding Servicing PCIe Cards. This includes using an antistatic wrist strap, powering off the server, removing of power supply cords, extending the server to the maintenance position, and removing the top cover.
2. For the nShield Solo+ card:
   • Attach the low profile bracket to the card. Refer to Chapter 4 of the Thales e-Security nShield Solo Installation Guide and the section titled "Fitting a module bracket."
   • Verify the Mode switch has remained in the O position.
3. Install the cryptographic card in to slot 5 of the KMA.