Launch the KMA QuickStart Program
There are two ways to launch the QuickStart from the ILOM: the web interface or the CLI.
Accessing the ILOM Interfaces
Connect to the ILOM IP address on the KMA Management Network (NET MGT). The ILOM can also be accessed by physically connecting a terminal to the SER MGT port on the KMA, but this is typically only done by an Oracle Service Representative during KMA installation or service.
The table below provides details about the Lights Out Manager interfaces available for each KMA server model.
Table 3-1 Lights Out Manager Interface for Each KMA Server Model
| KMA Server Model | Lights Out Manager Interface |
|---|---|
|
SPARC T7-1 or T8-1 Netra SPARC T4‐1 |
ILOM, Web or CLI |
|
Sun Fire X4170 M2 |
ILOM, Web only |
|
Sun Fire X2100 M2 Sun Fire X2200 M2 |
ELOM, Web only Refer to the OKM 2.5 documentation for more information. |
See Upgrade and Configure Integrated Lights Out Manager (ILOM) for additional procedures.
See the following documents for details about the ILOM for your KMA.
- Oracle ILOM Administrator's Guide for Configuration and Maintenance
- Oracle ILOM 3.1 Configuration and Maintenance Guide
What happens once the KMA startup completes?
The KMA behaves differently after startup depending on if it is in the factory-default state or was already configured.
- If the KMA is in the factory-default state, the KMA QuickStart program automatically launches and guides you through the initial KMA configuration. See Review QuickStart Information and Set Keyboard Layout.
- If the KMA has already been configured for your site, the OKM Console appears and you can display or make changes to the KMA configuration. See OKM Console.