Remove the Module Controller

The Module Controller latches into the upper-right rear of the Expansion Module.

Note:

Be aware of ESD (see Electrostatic Discharge).

1. Locate the Module Controller (see CRU Locations).
2. Power down the library (see Power Off the Library).
3. Disconnect the expansion cable plug from the input port on the Module Controller.
4. Disconnect the expansion cable plug from the output port on the Module Controller of a library with a tape capacity of greater than 300 tapes. This action applies to Module 6 through Module 10.
5. Pinch the latch tabs and pull the latch towards you.
   
6. Pull the controller card out of the module slot.
7. Set the Module Controller on the anti-static work surface.