Restore the Factory Default Configuration

Restore the library to factory defaults settings to erase the existing configuration.

Record any important library configuration information because restoring will erase all configuration information. Only reset the configuration as a last resort.

1. This procedure requires two people. One person at the front of the library and one at the rear. A single person cannot reach both buttons simultaneously.
2. Find the locator buttons — front upper left and rear top center (see below)
   

   
3. Push and release either one of the locator buttons.
4. Once the locator buttons light, simultaneously push and hold both front and rear buttons for about 10 seconds until the lights rapidly flash.

   Note:

   After 3-4 seconds, the lighted locator buttons flash slowly. After 10 seconds, the locator buttons should start to flash rapidly.

5. When the lighted locator buttons start flashing rapidly, release both buttons. The library is now reset to defaults. It should power down and restart.

   Note:

   If either Locate button is released before the fast flash rate, the reset process terminates.

6. If the library does not power-on automatically, press the power button.
   
7. Run the initial installation wizard and reconfigure the library as you would when setting up a new unit (see Configure the Library After Powering-on for the First Time).