Discovering FC Ports (CLI)

To discover FC ports, use the following CLI commands:
hostname:configuration san fc targets> show
Properties:
                      targets = wwn.2100001B32811639,wwn.2101001B32A12239
Targets:
NAME       MODE       WWN                     PORT                 SPEED
target-000 target     wwn.2100001B32811639    PCIe 5: Port 1       4 Gbit/s
target-001 initiator  wwn.2101001B32A11639    PCIe 5: Port 2       0 Gbit/s
target-002 initiator  wwn.2100001B32812239    PCIe 2: Port 1       0 Gbit/s
target-003 target     wwn.2101001B32A12239    PCIe 2: Port 2       0 Gbit/s
hostname:configuration san fc targets> select target-000
hostname:configuration san fc targets target-000> show
Properties:
                          wwn = wwn.2100001B32811639
                         port = PCIe 5: Port 1
                         mode = target
                        speed = 4 Gbit/s
             discovered_ports = 6
           link_failure_count = 0
           loss_of_sync_count = 0
         loss_of_signal_count = 0
         protocol_error_count = 0
        invalid_tx_word_count = 0
            invalid_crc_count = 0
Ports:
PORT      WWN                   ALIAS              MANUFACTURER
port-000  wwn.2100001B3281A339  longjaw-1          QLogic Corporation
port-001  wwn.2101001B32A1A339  longjaw-2          QLogic Corporation
port-002  wwn.2100001B3281AC39  thicktail-1        QLogic Corporation
port-003  wwn.2101001B32A1AC39  thicktail-2        QLogic Corporation
port-004  wwn.2100001B3281E339  <none>             QLogic Corporation
port-005  wwn.2101001B32A1E339  <none>             QLogic Corporation