SNMP Properties

The following table describes the SNMP properties.

Table 3-48 SNMP Properties

Property	Description
Version	Toggles between v1/2c and v3.
Community name	Toggles between public and user-input. If you select user-input, you must also enter a community name. If you select v3, this property is not available.
Authorized network/subnet	Enter an appropriate IPv4 address and subnet (integers from 0-32). If you select v3, this property is not available.
Appliance contact	Enter an appropriate appliance contact.
Username/password	Enter a valid username (max 501 characters) and password (8-501 characters). If you select v1/2c, this property is not available.
Authentication	Toggles between MD5 and SHA authentication algorithms. If you select v1/2c, this property is not available. Note that MD5 is no longer recommended and might be removed in a future release.
Privacy	Toggles among None, DES, and AES encryption algorithms. If you select v1/2c, this property is not available. Note that DES is no longer recommended and might be removed in a future release.
Engine ID	The EngineID value hashed by snmpd. If SNMP was not previously enabled, the label shows 0x000.
Trap destinations	Lets you add IPv4 addresses. Use the “+” and “-” buttons to add or remove addresses.

The SNMP service also provides the MIB-II location string. This property is sourced from the System Identity configuration.