Safety Information
This section contains safety information that you must follow when servicing the storage system. For your protection, observe the following safety precautions when setting up your equipment:
-
Do not remove the side panels, or run the storage system with the side panels removed. Hazardous voltage is present that could cause injury. The covers and panels must be in place for proper air flow to prevent equipment damage.
-
Follow all cautions, warnings, and instructions marked on the equipment and described in Important Safety Information for Oracle's Hardware Systems included with your system.
-
Ensure that the voltage and frequency of your power source match the voltage inscribed on the electrical rating label.
-
Follow the electrostatic discharge safety practices. Electrostatic discharge (ESD) sensitive devices, such as PCI cards, HDDs, SSDs, and memory cards, require special handling. Circuit boards and HDDs contain electronic components that are extremely sensitive to static electricity. Ordinary amounts of static electricity from clothing or the work environment can destroy the components located on these boards. Do not touch the components without using antistatic precautions, especially along the connector edges.
Note:
The Critical status indicator on the front panel flashes red when powering off and powering on the ZS5-2 or ZS3-2 storage controller. After the controller is powered on, the Power/OK status indicator is steady green, and the red Critical status indicator is off.