Adding an adapter and defining its job schedules using the command line

Previous Topic

Next Topic

Book Contents

Adding an adapter and defining its job schedules using the command line

  1. Open a Command Prompt window and enter the name of the drive in which the executable file is installed.

    Note: By default, the executable file is installed in the same location as the Central Coding application.

  2. Enter the location of the executable file in the drive that you specified:

    <Installation Folder>\CentralCodingServer\CodingWebUI\bin

    Note: You must run the application from this directory.

  3. Enter the following command for adding an adapter and defining its job schedules:

    PhaseForward.CentralCoding.SetAdapter.exe [AdapterName] [AdapterURL] [GetVerbatimsSchedule] [ReturnCodesSchedule]

    In the command syntax:

    • AdapterName—Name of the adapter to add.
    • AdapterURL—URL of the adapter to add.
    • GetVerbatimsSchedule—Rate at which to run the Get Requests job schedule. This parameter corresponds to the Time span configuration setting on the Schedule GetRequests Job page in the user interface.
      • 0—Indicates that you will run manual Get Requests jobs for the adapter, and the adapter should not be added to a Get Requests schedule.
      • 1—Set a Get Requests job schedule to run every minute for the adapter.
      • 5—Set a Get Requests job schedule to run every five minutes for the adapter.
      • 15—Set a Get Requests job schedule to run every fifteen minutes for the adapter.
      • 30—Set a Get Requests job schedule to run every thirty minutes for the adapter.

      Note: This parameter is optional.

    • ReturnCodesSchedule—Rate at which to run the Return Codes job schedule. This parameter corresponds to the Time span configuration setting on the Schedule ReturnCodes Job page in the user interface.
      • 0—Indicates that you will run manual Return Codes jobs for the adapter, and the adapter should not be added to a Return Codes schedule.
      • 1—Set a Return Codes job schedule to run every minute for the adapter.
      • 5—Set a Return Codes job schedule to run every five minutes for the adapter.
      • 15—Set a Return Codes job schedule to run every fifteen minutes for the adapter.
      • 30—Set a Return Codes job schedule to run every thirty minutes for the adapter.

      Note: This parameter is optional.

Send Feedback