) for the signal configuration, and then click Refresh.To refresh a signal configuration for the first time, you must use the Refresh Signal Management page. However, for future refreshes, you can use a definition file.
You must have the Manage Signal Configurations and Create Data Mining Runs user permissions to initiate a refresh.
After you refresh a signal configuration, you should not edit the signal configuration.
Note: You cannot schedule a refresh if a refresh is in progress.
1. Click Settings.
The Settings page appears.
2. In the Configure System section, click Manage Signal Configurations.
The Manage Signal Configurations page appears.
3. Click the row menu () for the signal configuration, and then click Refresh.
The Refresh Signal Management page appears.
4. Specify when to perform the refresh:
Run as soon as possible—The refresh is executed immediately.
Do not run until—The refresh is executed on the date and time that you specify.
5. To receive an email notification when the refresh is complete:
A. Select the Email me when complete check box.
B. Type one or more email addresses using a comma to separate each address.
The email addresses associated with your Empirica Signal user name appear by default. To change these email addresses, contact your site administrator.
6. Click Submit.
The Refresh Submitted page appears.
7. Click Continue.
The Signal Management Refresh page appears, and the refresh is listed in the table.