Configure domain partition available targets

To configure a domain partition available targets:

Note: This topic focuses on the management tasks you perform on the domain partition itself, and not on the associated resource groups.

If you have not already done so, in the Change Center of the Administration Console, click Lock & Edit (see Use the Change Center).
In the left pane of the Console, select Domain Partitions.
The Domain Partitions table displays all of the partitions defined in the domain.
Select the domain partition you want to configure.
Select the Domain Partition Configuration -> Available Targets page.
Select one or more existing virtual targets to be available for this domain partition to use. Multiple partitions cannot use the same virtual target. You can use a virtual target only with one partition at any one time. See Configuring Virtual Targets and About Partition Administrative Virtual Targets for more information on virtual targets.
Click Save.
To activate these changes, in the Change Center of the Administration Console, click Activate Changes.
Not all changes take effect immediately—some require a restart (see Use the Change Center).

After you finish

You perform most of the configuration required for a partition when you configure the resource group or resource group overrides. The tasks include configuring JDBC system data sources, JMS servers and resources, and foreign JNDI providers, and so forth.

If you did not create the resource group from a resource group template, edit the resource group as needed. See Configuring Resource Groups for additional information.

If you did create the resource group from a resource group template, see Configuring Resource Overrides for additional information.

Administration Console Online Help

Configure domain partition available targets