To edit a task help topic
that fulfills the minimal requirements:
- If you have not already done so, in the Change Center of the Administration Console, click Lock & Edit (see Use the Change Center).
-
In the left
pane of the Console, select Diagnostics > Diagnostic
Modules.
-
In the
Diagnostic System Modules table, select the name
of the diagnostic system module containing the thread dump action you
want to configure.
-
Select Configuration > Policies and Actions >
Actions.
-
In the Actions table, select the name of the thread dump
action you want to configure.
-
On the Thread Dump Properties page:
-
In Timeout (in seconds), enter the
interval of time length of time, in seconds, that this action has
to complete execution. The value you enter must be greater than
the number of thread dumps multipled by the value entered in
Delays (in seconds). A value of
0 indicates timeout disabled..
-
In Number of thread dumps, enter the
number of thread dumps that you want this action to capture.
-
In Delays (in seconds), enter the
delay, in seconds, to pause betweeen thread dumps captured by this
action.
-
Click Save.
-
In the Change Center, click Activate
Changes.
