Configure the Linux-PAM using SSSD
Configure the Oracle Identity Cloud Service Linux Pluggable Authentication Module (PAM) on Linux using the SSSD service.
Note:
The following prerequisites must be met before proceeding with the configuration.- The SSSD service should be installed. If it is not installed, install via
sudo yum install sssd
. - The service must be configured to start when the system reboots. You can perform this configuration via
sudo chkconfig sssd on
. - The property
SELINUX
must be set aspermissive
ordisabled
in file/etc/selinux/config
. If it is not set, then setSELINUX=permissive
orSELINUX=disabled
. - Restart Linux to incorporate the above changes.