|Oracle® Complex Event Processing Visualizer User's Guide
11g Release 1 (184.108.40.206.0)
Part Number E14302-04
This section contains the typical JMX tasks you can perform with Oracle CEP Visualizer, including:
For more information, see Section 9.3, "JMX Management".
Using the Oracle CEP Visualizer, you can view JMX configuration.
To view JMX configuration:
In the left pane, click the Domain > Server node, where Domain refers to the name of your Oracle CEP domain and Server refers to the name of the server instance.
In the right pane, click the JMX tab.
The JMX tab appears as Figure 12-1 shows.
Figure 12-1 JMX Tab
The JMX properties are displayed in the table:
jndi-service-name—The name of the JNDI service to which the JMX server will bind its object.
rmi-service-name—The name of the RMI service with which the JMX server will register to receive calls.
rmi-jrmp-port—The port on which to listen for RMI JRMP JMX requests.
rmi-registry-port—The port on which to start the RMIRegistry.
Note:Oracle CEP does not support the JRMP protocol: an Oracle CEP JMX client does not use the
rmi-registry-portproperties. Instead, JMX clients must use the more secure MSA protocol for both local and remote access to the Oracle CEP JMX server. When you connect to the Oracle CEP JMX server that is running on
localhostor on a remote host, you must always use the JMX URL
/jndi/jmxconnectorso that you are always using the MSA connector (where
localhostor the name of the remote host and
PORTis the Oracle CEP server JNDI port). For more information, see "Accessing the Oracle CEP JMX Server" in the Oracle Complex Event Processing Administrator's Guide.
For more information, see "Configuring JMX for Oracle CEP" in the Oracle Complex Event Processing Administrator's Guide.