2. Fibre Channel Configuration Overview
3. Administering Multipathing Devices Through mpathadm Commands
4. Configuring Multipathing Software
7. Configuring IPFC SAN Devices
8. Solaris 10 10/08 x86/x64 Fibre Channel Operating System Booting Procedure
9. Persistent Binding for Tape Devices
A. Manual Configuration for Fabric-Connected Devices
Fabric Device Node Configuration
Ensuring That LUN Level Information Is Visible
To Ensure LUN Level Information is Visible
To Detect Fabric Devices Visible on a Host
To Configure an Individual Device Without Multipathing
To Configure Multiple Devices Without Multipathing
Configuring Device Nodes With Solaris Multipathing Software Enabled
To Configure Individual Devices With Sun StorageTek Traffic Manager Software
To Configure Multiple Devices With Multipathing
To Unconfigure a Fabric Device
To Unconfigure All Fabric Devices on a Fabric-Connected Host Port
To Unconfigure One Path to a Multipathing Device
To Unconfigure All Fabric-Connected Devices With Multipathing Enabled
This section describes fabric device configuration tasks on a host that does not have multipathing enabled.
The procedures in this section show how to detect fabric devices that are visible on a host and to configure and make them available to a host using the Solaris 10 OS. The procedures in this section use specific devices as examples to illustrate how to use the cfgadm(1M) command to detect and configure fabric devices.
The device information that you supply and that is displayed by the cfgadm(1M) command depends on your system configuration.