CPU Modules
-
Each CPU/Memory+ board has two sets of CPU connectors, marked "PROC 0" and "PROC 1".
-
Do not mix CPU speeds.
-
Requirement-To run 250 MHz CPU modules: (1) use only clock+ board part number 501-4286 and (2) do not mix 250 MHz CPU modules with CPU modules of a different speed.
-
The order in which CPU slots are filled is not critical. However, to optimize heat dissipation in the system:
-
Fill all "PROC 0" locations on all CPU/Memory+ boards before filling any "PROC 1" locations. To receive the maximum quantity of diagnostic information, fill "PROC 0" on board 0.
-
After all "PROC 0" locations are filled, you can begin filling the "PROC 1" locations, again starting from the lowest slot number to the highest.
Table D-1 shows slot locations for an example of five CPUs on three CPU/Memory+ boards.
Table D-1 Example of CPU Placement|
Slot Number |
"PROC 0" |
"PROC 1" |
|---|---|---|
|
0 |
in |
in |
|
2 |
in |
in |
|
4 |
in |
-- |
- © 2010, Oracle Corporation and/or its affiliates