Replacing the Power Sequencer

1. Tilt the power sequencer inward and seat the bottom in the cabinet opening.

   There are two retainers at the bottom of the power sequencer which rest on the sheet metal at the bottom of the cabinet opening.

2. Tilt the power sequencer so that it is flush against the cabinet.

3. Replace the two screws at the bottom of the power sequencer (Figure E-3).

4. Replace the two screws at the top of the power sequencer.

5. Connect all the cable assemblies to the front of the power sequencer.

   Reach through the space uncovered by the side panel to replace these cable assemblies.

6. Replace the side panel closest to the power sequencer.

   See Chapter 12, Preparing for Service, for information on replacing the side panel.

7. Replace the power cord assembly at the back of the power sequencer.

   See "AC Power Cable", for information on replacing the power cord.

8. Power on the Enterprise system.

   See the power on instructions in Chapter 11, Powering Off and On .