Sun Management Center 3.6 Version 2 Add-On Software Release Notes: Addendum for Sun Fire T1000 Servers
This document is a supplement to the Sun Management Center 3.6 Version 2 Add-On Software Release Notes for Sun Fire, Sun Blade, and Netra Systems (819-4987) and to the Sun Management Center 3.6 Supplement for Sun Fire, Sun Blade and Netra Systems (819-1153). This addendum adds information about support for Sun Fire T1000 servers only. The document includes the following sections:
This section describes changes in Sun Management Center add-on software for Sun Fire, Sun Blade, and Netra systems between the release of Sun Management Center 3.6 software and this release of Sun Management Center 3.6 Version 2 add-on software.
This document covers only the Sun Fire T1000 servers.
Sun Management Center 3.6 Version 2 add-on software supports the following systems:
This document contains additional information to supplement the following documents:
Includes information about obtaining and installing this version of the add-on software, as well as minimum required software versions and recommended patches.
Provides instructions on how to install, configure, and use Sun Management Center software on the supported platforms. The preface contains a list of other related documentation.
In addition, the following documents relate to the Sun Fire T1000 systems:
Sun documentation can be found here:
New packages are installed with this release to support the newly supported model. TABLE 1 contains a list of the server and agent components for Sun Fire T1000 systems.
This section describes software bugs known at the time of this release and that you might notice or that can affect the operation of Sun Management Center 3.6 Version 2 add-on software. This list supplements the list documented in the Sun Management Center 3.6 Version 2 Add-On Software Release Notes for Sun Fire, Sun Blade, and Netra systems (819-4987).
During installation of the core Sun Management Center 3.6 software on Sun Fire T2000/T1000 systems, the following error messages might be displayed multiple times and should be ignored.
/opt/SUNWsymon/sbin/es-inst: /usr/platform/sun4u/sbin/prtdiag: not found
In the Module Manager tab, you can use Unload to unload the ELP Config-Reader Monitoring software module on a Sun Fire T2000/T1000 system. If you then use Load to reload the software module, the Module Browser information for the Sun Fire T2000/T1000 systems is not displayed.
Workaround: Perform the following for a temporary fix:
On Sun Fire T1000 systems, you might sometimes see erroneous Caution alarms relating to CPUs that do not exist on the system in question.