test

SunCD 4 Drive Specifications

Setting the SCSI Target ID

Your CD-ROM device is factory-set to SCSI target ID 6.

To install the SunCD 4 drive into a device using a target ID selector switch:

  1. Remove the jumpers from ID1, ID2, and ID4.

  2. Connect the flex cable from the target ID switch on the rear panel of the enclosure to the ID jumpers on the CD-ROM drive.

  3. Set the target ID selector switch on the enclosure to 6.

To install the SunCD 4 drive into a system platform:

  1. Set the jumpers to SCSI target ID 6 by installing jumpers ID4 and ID2 as shown below.

    Graphic