The stereo connector allows connection of stereo goggles to the Creator Graphics Accelerator. Two versions of stereo connector are used on the Creator Graphics Accelerator: a female, three-conductor, mini-phone connector used on the Series 1 board and a seven-pin DIN connector used on the Series 2 board.
The stereo connector for the Creator Series 1 board is a female, three-conductor, mini-phone connector, as shown in Figure 2-1.
The stereo connector for the Creator Series 2 and Series 3 boards is a seven-pin DIN connector, as shown in Figure 2-2.
Table 2-4 lists the stereo cable signals.
Table 2-4 Creator Series 2 and Series 3 Stereo Connector Signals
Pin |
Description |
---|---|
1 |
Ground |
2 |
No connection |
3 |
+12V |
4 |
STEREO signal |
5 |
No connection |
6 |
No connection |
7 |
No connection |
The STEREO signal is a TTL-level, 50 percent duty cycle signal that switches between left and right stereo shutters, as shown in Figure 2-3.
A stereo cable and goggles for use with the Creator Graphics Accelerator are available from the following source:
StereoGraphics Corporation 2171-H East Francisco Blvd. San Rafael, CA 94901 (415) 459-4500 FAX: 415-459-3020