test

Sun Cluster Data Service for WebSphere MQ Guide for Solaris OS

ProcedureExample: Prepare the Cluster for WebSphere MQ

  1. Install and configure the cluster as instructed in Sun Cluster Software Installation Guide for Solaris OS.

    Install the following cluster software components on node Vigor5.

    • Sun Cluster core software

    • Sun Cluster data service for WebSphere MQ

    • Sun Cluster data service for Solaris Containers

  2. Add the logical host name to /etc/hosts and /etc/inet/ipnodes in the global zone and failover zone.

    The following output shows the logical host name entry for qmgr3 in the global zone.


    Vigor5# grep qmgr1 /etc/hosts /etc/inet/ipnodes
/etc/hosts:192.168.1.150	qmgr1
/etc/inet/ipnodes:192.168.1.150	qmgr1

  3. Install and configure a Zettabyte File System

    Note –

    The following zpool definition represents a very basic configuration for deployment on a single-node cluster.

    You should not consider this example for use within a productive deployment, instead it is a very basic configuration for testing or development purposes only.

    Create a ZFS pool


    Vigor5# zpool create -m /ZFSwmq3/log HAZpool1 c1t1d0
Vigor5# zpool create -m /ZFSwmq3/qmgr HAZpool2 c1t4d0

  4. Install and Configure a Solaris Volume Manager File System

    Note –

    The following metaset definitions represent a very basic configuration for deployment on a single-node cluster.

    You should not consider this example for use within a productive deployment, instead it is a very basic configuration for testing or development purposes only.

    1. Create a SVM Disk Set.


      Vigor5# metaset -s dg_d1 -a -h Vigor5

    2. Add a Disk to the SVM Disk Set


      Vigor5# metaset -s dg_d1 -a /dev/did/rdsk/d2

    3. Add the Disk Information to the metainit utility input file 


      Vigor5# cat >> /etc/lvm/md.tab <<-EOF
dg_d1/d100      -m      dg_d1/d110
dg_d1/d110      1 1     /dev/did/rdsk/d2s0
EOF

    4. Configure the metadevices


      Vigor5# metainit -s dg_d1 -a

    5. Create a Mount Point for the SVM Highly Available Local File System


      Vigor5# mkdir /FOZones

    6. Add the SVM highly available local file system to /etc/vfstab 


      Vigor5# cat >> /etc/vfstab <<-EOF
/dev/md/dg_d1/dsk/d100 /dev/md/dg_d1/rdsk/d100 /FOZones ufs 3 no logging
EOF

    7. Create the File System


      Vigor5# newfs /dev/md/dg_d1/rdsk/d100

    8. Mount the File System


      Vigor5# mount /FOZones