These error messages are generated when the SunVTS serial parallel controller discovers any errors. The error descriptions below identify probable causes for the card or test failure, and identify the Field Replaceable Unit (FRU), if possible. The three FRUs affected are: the serial parallel controller card, the 96-pin shielded cable, and the patch panel.
Table 33-4 spiftest Error Messages
|
Error Message |
Probable Cause(s) |
Recommended Action |
---|---|---|---|
6000 |
error_message |
|
|
6001 |
Expected = value, observed = value |
|
|
6002 |
Expected value: |
|
|
6003 |
Observed value: |
|
|
6004 |
Modem Loopback test failed on device_name |
|
|
6005 |
Off-line error on device device_name |
|
|
6006 |
Paper out error on device device_name |
|
|
6007 |
Busy error on device device_name |
|
|
6008 |
Error on device device_name |
|
|
6009 |
retry number exceeds limit number rc =s value |
|
|
6010 |
Expected number bytes, observed number bytes |
|
|
6011 |
Internal test failed on device_name |
|
|
6012 |
Data Loopback test failed on device_name |
|
|
6013 |
ioctl TIOCSSOFTCAR error on device_name |
|
|
8000 |
Must provide device name! |
|
|
8001 |
No SPC/S card found or device driver not installed |
|
|
8002 |
ioctl TCSETS failed on device_name |
|
|
8003 |
Open error on device_name - device driver may not be installed properly |
|
|
8004 |
Device device_name is already opened |
|
|
8005 |
ioctl STC_SREGS(STC_IOREG-COR2) error in device_name |
|
|
8006 |
ioctl STC_GREGS(STC_IOREG-CCR) error in device_name |
|
|
8007 |
ioctl STC_S1REGS(STC_IOREG-CCR) error in device_name |
|
|
8008 |
ioctl STC_SREGS(STC_PPCREG-PDATA) error in device_name |
|
|
8009 |
ioctl STC_GREGS(STC_PPCREG-PDATA) error in device_name |
|
|
8011 |
ioctl TIOCMGET failed on device_name |
|
|
8012 |
device_name: Expected DSR set, observed clear |
|
|
8013 |
device_name: Expected DSR clear, observed set |
|
|
8014 |
ioctl TIOCMSET failed on device_name |
|
|
8015 |
ioctl TIOCMBIC failed on device_name |
|
|
8016 |
Read error on device_name |
|
|
8017 |
Write error on device_name |
|
|
8018 |
ioctl STC_GPPC error on device device_name |
|
|
8019 |
Can't kill all processes |
|
|
8020 |
Timeout error on device_name. |
There is no loopback plug |
Check the loopback plug. |
8021 |
Timeout error on device_name |
TTY terminal not connected |
Check the TTY terminal connection. |
8022 |
Timeout error on device_name |
|
|