Skip Navigation Links | |
Exit Print View | |
Oracle Solaris Cluster 3.3 With SCSI JBOD Storage Device Manual |
1. Installing a SCSI JBOD Storage Device
2. Maintaining a SCSI JBOD Storage Device
Sun StorEdge 3120 Cabling Diagrams
Installing a Sun StorEdge 3120 Storage Array
Sun StorEdge 3310 and 3320 SCSI Cabling Diagrams
Installing a Sun StorEdge 3310 or 3320 Storage Array
Adding a Sun StorEdge 3310 or 3320 Storage Array
SPARC: Sun StorEdge D1000 Cabling Diagrams
SPARC: Installing a Sun StorEdge D1000 Storage Array
SPARC: Adding a Sun StorEdge D1000 Storage Array
SPARC: Sun StorEdge Multipack Cabling Diagrams
SPARC: Installing a Sun StorEdge Multipack Storage Array
SPARC: Adding a Sun StorEdge Multipack Storage Array
SPARC: Replacing a Sun StorEdge Multipack Storage Array
SPARC: Removing a Sun StorEdge Multipack Storage Array
SPARC: Sun StorEdge Netra D130/S1 Cabling Diagrams
SPARC: Installing a Sun StorEdge Netra D130/S1 Storage Array
SPARC: Adding a Sun StorEdge Netra D130/S1 Storage Array
SPARC: Replacing a Sun StorEdge Netra D130/S1 Storage Array
SPARC: Removing a Sun StorEdge Netra D130/S1 Storage Array
SPARC: Sun StorEdge D2 Cabling Diagrams
SPARC: Installing a Sun StorEdge D2 Storage Array
Connect the cables to the storage arrays, as shown in Figure 3-6.
Ensure that the entire bus length that is connected to each storage array is less than 25 m. This measurement includes the cables to both nodes, as well as the bus length that is internal to each storage array, node, and the host adapter.
Figure 3-6 SPARC: Installing a Sun StorEdge D1000 Mirrored-Pair Configuration: An Example
Ensure that the entire SCSI bus length to each enclosure is less than 25 m. This measurement includes the cables to both nodes, as well as the bus length that is internal to each enclosure, node, and host adapter. Refer to the documentation that shipped with the enclosure for other restrictions about SCSI operation.
Figure 3-7 SPARC: Adding a Sun StorEdge D1000 Mirrored-Pair Configuration: Part 1
Connect the storage array to the host adapters by using differential SCSI cables as shown in see Figure 3-8.
Figure 3-8 SPARC: Adding a Sun StorEdge D1000 Mirrored-Pair Configuration: Part 2
Disconnect the SCSI cables from the storage array. Remove the SCSI cables in the order that is shown in Figure 3-9.
Figure 3-9 SPARC: Disconnecting the SCSI Cables From a Sun StorEdge D1000 Storage Array
Disconnect the SCSI cables from the storage array. Remove the SCSI cables in the order that is shown in Figure 3-10.
Figure 3-10 SPARC: Disconnecting the SCSI Cables From a Sun StorEdge D1000 Storage Array