Index
Symbols
- -> commands
- reset /SYS, 1
- set /HOST/bootmode, 1
- set /SYS/LOCATE, 1
- show /SYS/LOCATE, 1
- -> prompt
- about, 1, 2
- accessing from network management port, 1
- accessing from serial management port, 1
- multiple sessions, 1
- system console escape sequence (#.), 1
- system console, switching between, 1
- ways to access, 1
- /etc/remote file, 1
- modifying, 1
A
- Activity
(disk drive LED), 1
- activity
indicator, 1
- alarm
- status indicators, 1
- alphanumeric terminal
- accessing system console from, 1
- setting baud rate, 1
- auto-boot (OpenBoot
configuration variable), 1, 2
- automatic system recovery (ASR)
- about, 1
- commands, 1
- disabling, 1
- enabling, 1
- obtaining recovery information, 1
B
- Break key (alphanumeric terminal), 1
C
- cables, keyboard and mouse, 1
- cfgadm (Solaris
command), 1
- cfgadm install_device (Solaris command),
cautions against using, 1
- cfgadm remove_device (Solaris
command), cautions against using, 1
- Cisco AS2511-RJ
Terminal Server, connecting, 1
- command prompts,
explained, 1
- communicating with the system
- about, 1
- options, table, 1
- console
configuration, connection alternatives explained, 1
- critical alarm, 1
D
- default system console configuration, 1
- device reconfiguration, manual, 1
- device unconfiguration,
manual, 1
- device, disabling, 1
- device, enabling, 1
- disabling a device, 1
- disk configuration
- RAID 0, 1
- RAID 1, 1
- disk drives
- LEDs
- Activity, 1
- OK-to-Remove, 1
- logical device names, table, 1
- disk hot-plug
- mirrored disk, 1
- nonmirrored disk, 1
- disk
slot number, reference, 1
- disk volumes
- about, 1
- deleting, 1
- dtterm (Solaris
utility), 1
- Dynamic Host Configuration Protocol (DHCP)
client on network management port, 1
E
- enabling a device, 1
- environmental information, viewing, 1
- error handling, summary, 1
- escape
sequence (, 1
G
- graceful system
halt, 1, 2
- graphics monitor
- accessing system console from, 1
- connecting to PCI graphics card, 1
- restrictions against using for initial setup, 1
- restrictions against using to view POST output, 1
H
- halt,
gracefully, advantages of, 1, 2
- hardware disk mirror
- about, 1
- hot-plug operation, 1
- hardware disk mirrored volume
- checking the status of, 1
- hardware disk stripe
- about, 1
- hardware disk striped volume
- checking the status of, 1
- hardware
disk striping, about, 1
- hot-plug operation
- nonmirrored disk drive, 1
- on hardware disk mirror, 1
I
- ILOM commands
- reset /SYS, 1
- show, 1
- ILOM,See Integrated Lights Out Manager (ILOM)
- init (Solaris
command), 1, 2
- input-device (OpenBoot
configuration variable), 1, 2
- Integrated
Lights Out Manager (ILOM)
- -> prompt,See -> prompt
- commands,See -> prompt
- escape sequence (, 1
- logging in, 1
- multiple connections to, 1
L
- LEDs, 1
- Activity (disk drive LED), 1
- alarm status, 1
- critical, 1
- major, 1
- minor, 1
- user, 1
- OK-to-Remove (disk drive LED), 1
- rear panel, 1
- server status, 1
- LEDs, Locator (system status LED), 1
- Locator
(system status LED)
- controlling from-> prompt, 1
- Locator (system status LED), controlling, 1
- locator
indicator, 1
- logging in to the Integrated Lights Out Manager (ILOM), 1
- logical device name
(disk drive), reference, 1
M
- major alarm, 1
- manual device reconfiguration, 1
- manual
device unconfiguration, 1
- manual system reset, 1, 2
- minor alarm, 1
- monitor,
attaching, 1
- multiple
ILOM sessions, 1
N
- network management
port (NET MGT)
- activating, 1
- nonmirrored disk hot-plug operation, 1
- normally
- closed (NC) relay state, 1
- open (NO) relay state, 1
- ntwdt driver, 1
O
- ok prompt
- about, 1
- accessing with Break key, 1
- accessing with graceful system shutdown, 1
- accessing with ILOMset /HOST break_action=break command, 1
- accessing with ILOMset /HOST send_break_action=break command, 1
- accessing with manual system reset, 1, 2
- suspension of Solaris operating system, 1
- ways to access, 1
- OK-to-Remove
(disk drive LED), 1
- OpenBoot commands
- probe-ide, 1
- probe-scsi-all, 1
- reset-all, 1
- setenv, 1
- OpenBoot configuration variables
- auto-boot, 1, 2
- described, table, 1
- input-device, 1, 2
- output-device, 1, 2
- system console settings, 1
- OpenBoot emergency procedures
- performing, 1
- USB keyboard commands, 1
- OpenBoot firmware
- scenarios for control, 1
- output-device (OpenBoot
configuration variable), 1, 2
P
- parity, 1
- patch panel,
terminal server connection, 1
- PCI graphics card
- configuring to access system console, 1
- connecting graphics monitor to, 1
- frame buffers, 1
- physical device
name (disk drive), 1
- probe-ide (OpenBoot
command), 1
- probe-scsi-all (OpenBoot
command), 1
R
- RAID (redundant array of independent
disks), 1, 2
- RAID 0 (striping), 1
- RAID 1 (mirroring), 1
- raidctl (Solaris
command), 1-2
- rear panel
- LEDs, 1
- relay state
- normally closed (NC), 1
- normally open (NO), 1
- reset
- manual system, 1, 2
- scenarios, 1
- reset /SYS (ILOM command), 1
- reset-all (OpenBoot command), 1
- run levels
- explained, 1
- ok prompt and, 1
S
- SER
MGT,See serial management port
- serial management
port (SER MGT)
- acceptable console device connections, 1
- as default communication port on initial startup, 1
- configuration parameters, 1
- default system console configuration, 1
- using, 1
- service
required indicator, 1
- set /HOST/bootmode (-> command), 1
- set /SYS/LOCATE (-> command), 1
- setenv (OpenBoot
command), 1
- show (ILOM
CMT command), 1
- shutdown (Solaris
command), 1, 2
- Solaris commands
- cfgadm, 1
- cfgadm install_device, cautions against
using, 1
- cfgadm remove_device, cautions against
using, 1
- init, 1, 2
- raidctl, 1
- shutdown, 1, 2
- tip, 1
- uadmin, 1
- uname, 1
- uname -r, 1
- status indicators, 1
- alarm, 1, 2
- critical, 1
- major, 1
- minor, 1
- user, 1
- server, 1
- Stop-D (USB keyboard functionality), 1
- Stop-F (USB keyboard functionality), 1
- Stop-N (USB keyboard functionality), 1
- system console
- -> prompt, switching between, 1
- accessing with alphanumeric terminal, 1
- accessing with graphics monitor, 1
- accessing with terminal server, 1, 2
- accessing with tip connection, 1
- alphanumeric terminal connection, 1, 2
- alternate configurations, 1
- configuring local graphics monitor to access, 1
- connection using graphics monitor, 1
- default configuration explained, 1, 2
- default connections, 1
- defined, 1
- Ethernet attachment through network management port, 1
- graphics monitor connection, 1, 2
- multiple view sessions, 1
- setting OpenBoot configuration variables for, 1
- system reset scenarios, 1
- system status LEDs
- Locator, 1
- system status LEDs, Locator, 1
T
- terminal server
- accessing system console from, 1, 2
- connection through patch panel, 1
- pinouts for crossover cable, 1
- tip (Solaris
command), 1
- tip connection
- accessing system console, 1
- accessing terminal server, 1
U
- uadmin (Solaris
command), 1
- uname (Solaris
command), 1
- uname -r (Solaris
command), 1
- user alarm, 1
W
- watchdog timer
- APIs, 1
- application mode, 1
- data structures, 1
- disabling, 1
- enabling, 1
- error messages, 1
- example program, 1
- getting state of, 1
- IOCTLs, 1
- limitations, 1
- rearming, 1
- setting timeout period, 1
Sun Netra T5440 Server | 820-4443-11 |
|
Copyright © 2010, Oracle and/or its affiliates. All rights reserved.