JavaScript is required to for searching.
Skip Navigation Links
Exit Print View
Sun Ethernet Fabric Operating System Uplink Port Trailing Administration Guide
Oracle Technology Network
Library
PDF
Print View
Feedback
search filter icon
search icon

Document Information

Using This Documentation

Sun Ethernet Fabric Operating System Uplink Port Trailing Protocol

Uplink Port Trailing Topology Example

Configure NEM24p-0

Configure NEM24p-1

Configure the ToR72

Verify the Configurations

Configure the Host

Verify the Uplink Port Trailing Feature

Configure the Host

  1. Configure the Host-1 interface to accept VLAN 300 and 301 traffic.
    [Host-1]# ifconfig -a
     
    eth4.300  Link encap:Ethernet  HWaddr 90:E2:BA:79:83:94
              inet addr:192.168.30.20  Bcast:192.168.30.255  Mask:255.255.255.0
              inet6 addr: fe80::92e2:baff:fe79:8394/64 Scope:Link
              UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
              RX packets:374 errors:0 dropped:0 overruns:0 frame:0
              TX packets:377 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:0
              RX bytes:30622 (29.9 KiB)  TX bytes:35858 (35.0 KiB)
     
    eth4.301  Link encap:Ethernet  HWaddr 90:E2:BA:79:83:94
              inet addr:192.168.31.20  Bcast:192.168.31.255  Mask:255.255.255.0
              inet6 addr: fe80::92e2:baff:fe79:8394/64 Scope:Link
              UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
              RX packets:2 errors:0 dropped:0 overruns:0 frame:0
              TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:0
              RX bytes:92 (92.0 b)  TX bytes:468 (468.0 b)
    
  2. Configure a bond interface using two interfaces connecting to the NEM24p-0 and NEM24p-1 such that the bond interface accepts both VLAN 300 and 301 traffic.
    [Host-2]# cat /proc/net/bonding/bond0 
    Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)
     
    Bonding Mode: fault-tolerance (active-backup)
    Primary Slave: eth7 (primary_reselect always)
    Currently Active Slave: eth7
    MII Status: up
    MII Polling Interval (ms): 100
    Up Delay (ms): 0
    Down Delay (ms): 0
     
    Slave Interface: eth6
    MII Status: up
    Speed: 10000 Mbps
    Duplex: full
    Link Failure Count: 5
    Permanent HW addr: 00:1b:21:66:48:ec
    Slave queue ID: 0
     
    Slave Interface: eth7
    MII Status: up
    Speed: 10000 Mbps
    Duplex: full
    Link Failure Count: 11
    Permanent HW addr: 00:1b:21:66:48:ed
    Slave queue ID: 0
     
    [Host-2]# ifconfig -a
     
    bond0.300 Link encap:Ethernet  HWaddr 00:1B:21:66:48:EC
              inet addr:192.168.30.50  Bcast:192.168.30.255  Mask:255.255.255.0
              inet6 addr: fe80::21b:21ff:fe66:48ec/64 Scope:Link
              UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
              RX packets:374 errors:0 dropped:0 overruns:0 frame:0
              TX packets:536 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:0
              RX bytes:30622 (29.9 KiB)  TX bytes:45960 (44.8 KiB)
     
    bond0.301 Link encap:Ethernet  HWaddr 00:1B:21:66:48:EC
              inet addr:192.168.31.50  Bcast:192.168.31.255  Mask:255.255.255.0
              inet6 addr: fe80::21b:21ff:fe66:48ec/64 Scope:Link
              UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
              RX packets:0 errors:0 dropped:0 overruns:0 frame:0
              TX packets:39 errors:0 dropped:0 overruns:0 carrier:0
              collisions:0 txqueuelen:0
              RX bytes:0 (0.0 b)  TX bytes:2646 (2.5 KiB)
     
     
     
     
    NEM24p-1 SEFOS# sh uplink-trailing group 20 detail 
    Uplink Trailing Group 20
    Description:     Uplink-trailing between NEM24p-1 & ToR72p-1
            Admin Status:            Enabled
            Status:                  Up 
    Link State Change: Up   1       Down    0 
     
    Port             Type   Status 
    Ex0/1        uplink      Up 
    Ex0/18       downlink    Up