How to Access Pc-Check Through the ILOM Web Interface

1. Determine the current IP address of the ILOM SP from one of the following locations:

   • CLI command– The SP has a serial port to which you can attach a terminal device. If you log in to the SP and enter the CLI command show /SP/network, the SP displays the current IP address.

   • System BIOS Setup screen– Press F2 during power-on, then choose Advanced > IPMI 2.0 Configuration > Set LAN Configuration > IP Address.

2. Connect to the ILOM SP through a web browser running on a remote system.

   To establish a connection to the ILOM SP web interface, type the IP address of the ILOM SP in the browser locator box and press Enter.

3. Log in to the ILOM web interface using your user name and password.
4. Select Remote Control > Diagnostics.

   The Diagnostics page appears.

5. From the Run Diagnostics on Boot drop-down list, select one of the following options to run during startup and click Save:

   • Disabled

   • Enabled

   • Extended

   • Manual

6. Select the Remote Power Control tab.

   The Remote Power Control page appears.

7. From the Select Action drop-down list, select Power Cycle and click Save to reboot the server.

   ---

   Note - Pc-Check diagnostics do not boot unless Power Cycle is selected. Selecting Reset does not boot Pc-Check diagnostics.

   ---

   If you chose the Enabled option, basic diagnostics are run, which takes about 3 minutes to complete. If you chose the Extended option, detailed diagnostics are run, which takes about 30 minutes to complete. If you chose the Manual option, the system boots to the Pc-Check main menu. The following main menu options appear:

   • System Information Menu

   • Advanced Diagnostics Tests

   • Immediate Burn-in Testing

   • Deferred Burn-in Testing

   • Create Diagnostic Partition

   • Show Results Summary

   • Print Results Report

   • About Pc-Check

   • Exit to DOS

     To run a specific hardware component test, select Advanced Diagnostics Test. To run one of the test scripts supplied by Oracle, select Immediate Burn-in Testing.

     Navigate through the menu items by pressing the arrow keys to move to a menu selection. Press the Enter key to select a menu selection, and press the ESC key to exit a menu. Navigation instructions are shown at the bottom of each screen.