Verify the Installation (Oracle SPARC)

Before You Begin

1. Power on and boot the blade server.
2. Display the ok prompt (OpenBoot prompt).

   Refer to the server’s Administration Guide for instructions on how to display the ok prompt.

3. List the network devices on your system.

   ok show-nets
   a) /pci@500/pci@0/pci@8/network@0,1
   b) /pci@500/pci@0/pci@8/network@0
   c) /pci@400/pci@0/pci@9/network@0,1
   d) /pci@400/pci@0/pci@9/network@0
   e) /pci@400/pci@0/pci@2/network@0,1
   f) /pci@400/pci@0/pci@2/network@0
   q) NO SELECTION
   Enter Selection, q to quit: q

   ---

   Note - Checking the .properties output for each device is the surest way to identify the device.

   ---

4. Check the .properties output for each device.

   The following examples assume that /pci@500/pci@0/pci@8/network@0,1 is a port on the EM.

   1. Move to the device directory.

      ok cd /pci@500/pci@0/pci@8/network@0,1

   2. Display the properties for the device.

      ok .properties

      The output should be similar to the following:

      ok .properties
      assigned-addresses       c3050010 00000001 00000000 00000000 00200000
                               81050018 00000000 00001000 00000000 00000020
                               c3050020 00000001 00200000 00000000 00004000
                               82050030 00000000 00300000 00000000 00080000
      reg                      00050000 00000000 00000000 00000000 00000000
                               43050010 00000000 00000000 00000000 00200000
                               01050018 00000000 00000000 00000000 00000020
                               43050020 00000000 00000000 00000000 00004000
                               02050030 00000000 00000000 00000000 00080000
      local-mac-address        a0 36 9f 02 37 ec
      version                  Sun Dual Port 10GBase-T ExpressModule
                               FCode version 3.11 1/25/12
      phy-type                 xgc
      board-model              701-4780
      model                    ATC:701-4781, PTO:701-4779
      compatible               pciex8086,1528.108e.7b14.1
                               pciex8086,1528.108e.7b14
                               pciex8086,1528.1
                               pciex8086,1528
                               pciexclass,020000
                               pciexclass,0200
      address-bits             00000030
      max-frame-size           00002400
      network-interface-type   ethernet
      device_type              network
      name                     network
      fcode-rom-offset         00000000
      interrupts               00000002
      cache-line-size          00000010
      class-code               00020000
      subsystem-id             00007b14
      subsystem-vendor-id      0000108e
      revision-id              00000001
      device-id                00001528
      vendor-id                00008086

      If you do not see the device listed, check that the EM is properly seated. If necessary, reinstall the EM.

   3. Type the following when you finish looking at the .properties values.

      ok device-end

Related Information

• Install the EM