Copyright © 2012, Oracle and/or its affiliates. All rights reserved. Legal Notices
This procedure describes how to log in to the Sun Ray Administration tool.
If your Admin GUI session is inactive for 30 minutes, you must log in again. To change the timeout value, see Section 4.6, “How to Change the Admin GUI Timeout”.
Log in to your Sun Ray server's console or to any client attached to it.
Open a browser window and type the following URL:
http://localhost:1660
If you specified a different port number when you configured the Sun Ray Software, use that port number in the URL. If you enabled secure communication, the browser might be redirected to a secure port. The default secure port is 1661.
In the User Name window, type the administrator user name and click OK.
In the password challenge screen, type the administration password and click OK.
The Sun Ray Administration tool appears.
If you get a message denying access, check the following items:
You are running a browser on a Sun Ray server or one of its clients.
The browser is not using a different machine as an HTTP proxy server.
If you get a blank browser page:
To access the Admin GUI from a system instead of the Sun Ray server, you must have remote access enabled (it is disabled by default). To enable remote access to the Admin GUI, unconfigure the Admin GUI using the utconfig -w -u command and then run utconfig -w to reconfigure. Choose Yes to enable remote access.
Copyright © 2012, Oracle and/or its affiliates. All rights reserved. Legal Notices