A script enabled browser is required for this page to function properly.
Skip to main content
StorageTek Tape Analytics Configuration Guide, Version 1.0.2
E28378-04
Table of Contents Previous Next Index


Configuring the Libraries for STA : Library Configuration Process : ▼ Set the SL500 Volume Label Format

▼

Set the SL500 Volume Label Format

Note – This procedure applies only to the SL500 library.

Use these two CLI procedures to ensure that volume serial numbers (VSNs) are formatted correctly in SNMP data sent to the STA server. This allows STA to correctly process library exchange data. See “Volume Label Formatting” for details.

Caution – If these parameters are not set properly, VSNs will be formatted incorrectly for STA. This will cause 1) exchanges processing to be blocked, 2) superfluous attempts by STA to get the latest media data from the library, and 3) irreversible, eight-character VSN records to appear on the Media - Overview screen whenever the “Show Removed Media” preference is set.

▼

Set the Host Label Orientation
1.
Display the current setting of the orientlabel flag.

2.
“Host” must be set to “left6”. To do so, use the following command:

3.
Display the setting again to verify that it was updated correctly.

▼

Set STA Mode
1.
Display the current setting of the STAconfig flag.

2.
STA mode must be enabled. To enable the flag, use the following command:

3.
Display the flag setting again to verify that it was updated correctly.

4.
You have finished configuring the SL500 library for STA and can go to Chapter 2, “Configuring SNMP in the STA Application”.
Table of Contents Previous Next Index Link to documentation
Copyright © 2012, 2013 Oracle and/or its affiliates. All rights reserved. Legal Notices