| | |
Language
| Select from the list of available languages for the OS.
| English*
|
Locale
| Select your geographic region from the list of available locales.
| English (C - 7-bit ASCII)*
|
Terminal
| Select the type of terminal that you are using from the list of available
terminal types.
|
|
Network connection
| Is the system connected to a network?
|
|
DHCP
| Can the system use Dynamic Host Configuration Protocol (DHCP) to configure
its network interfaces?
|
|
If you are not using DHCP, supply the network information
| Supply a static IP address for the system. Example: 129.200.9.1
|
|
Supply the netmask of the subnet. Example: 255.255.0.0
| 255.255.0.0*
|
Enable IPv6 on this machine?
|
|
Host name
| Choose a host name for the system.
|
|
Kerberos
| Do you want to configure Kerberos security on this machine? If yes,
gather this information:
|
|
Name service
| If applicable, which name service should this system use?
|
|
Provide the name of the domain in which the system resides.
|
|
If you chose NIS+ or NIS, do you want to specify a name server, or let
the installation program find one?
|
|
If you chose DNS, provide the IP addresses for the DNS server. You must
enter at least one IP address, but you can enter up to three addresses. You can also enter a list of domains to search when a DNS query is made. Search domain: Search domain: Search domain:
|
|
If you chose LDAP, provide the following information about your LDAP
profile: Profile name
Profile server
If you specify a proxy credential level in your LDAP profile, gather
the following information:
|
|
Default route
| Do you want to specify a default route IP address, or let the OS installation
program find one? The default route provides a bridge that forwards traffic between two
physical networks. Choices: You can specify the IP address. An /etc/defaultrouter file
is created with the specified IP address. When the system is rebooted, the
specified IP address becomes the default route.
You can let the OS installation program detect an IP address.
However, the system must be on a subnet that has a router that advertises
itself by using the Internet Control Message Protocol (ICMP) for router discovery.
If you are using the command-line interface, the software detects an IP address
when the system is booted.
You can select None if you do not have a router or do not
want the software to detect an IP address at this time. The software automatically
tries to detect an IP address on reboot.
| Specify one
Detect one
None*
|
Time zone
| How do you want to specify your default time zone?
| Geographic region*
Offset from GM
Time zone file
|
Root password
| Choose a root password for the system.
|
|