|Skip Navigation Links|
|Exit Print View|
|Oracle VM Server for SPARC 3.0 Administration Guide Oracle VM Server for SPARC|
Some of the Oracle VM Server for SPARC networking features work differently when a domain runs the Oracle Solaris 10 OS as compared to the Oracle Solaris 11 OS. The following describes the feature differences for the Oracle VM Server for SPARC virtual network device and virtual switch when the Oracle Solaris 11 OS is run in a domain:
Configuring the vswn device as the primary network interface to enable a service domain to communicate with guest domains
This configuration is only required for domains that run the Oracle Solaris 10 OS. For Oracle Solaris 11, a virtual switch uses the Oracle Solaris 11 network stack, automatically enabling its virtual network devices to communicate with the network interface that corresponds to its back-end device, such as net0.
Using an Oracle Solaris 11 etherstub device as a back-end device to create a private virtual switch
Using this device enables a guest domain to communicate with a zone that is configured in an Oracle Solaris 11 service domain.
Using generic names for the virtual switch and virtual network devices
The Oracle Solaris 11 OS assigns generic names for vswn and vnetn devices. So, ensure that you do not create a virtual switch with the back-end device that is another vsw or vnet device. Use the dladm show-phys command to see the actual physical devices that are associated with generic network device names.
Using VNICs on the virtual switch and virtual network devices
You cannot use VNICs on vswn and vnetn devices. An attempt to create a VNIC on vswn and vnetn fails. See Oracle Solaris 11: Zones Configured With an Automatic Network Interface Might Fail to Start in Oracle VM Server for SPARC 3.0 Release Notes.