How to Recover From an Oracle ZFS Storage Appliance Remote Replication Error

Language:

To recover from an error state, you might perform some or all of the steps in the following procedure.

Use the procedures in the Oracle ZFS Storage Appliance documentation to determine the causes of the Faulted state.
Recover from the Faulted state by using the Oracle ZFS Storage Appliance procedures.
If the recovery procedures change the state of the component, this state is automatically detected by the resource and is reported as a new protection group state.
Revalidate the protection group configuration.
```
phys-paris-1# geopg validate protection-group
```
protection-group

Specifies the name of the Oracle ZFS Storage Appliance protection group.
- If the geopg validate command determines that the configuration is valid, the state of the protection group changes to reflect that fact.
- If the configuration is not valid, the geopg validate command returns a failure message.
Review the status of the protection group configuration.
```
phys-paris-1# geopg list protection-group
```
Review the runtime status of the protection group.
```
phys-paris-1# geoadm status
```