How to Turn On Debugging for HA for Samba

Perform this procedure on each node in the cluster.

1. Display the /etc/syslog.conf file entries that contain the word "daemon".

   phys-schost-N# grep daemon /etc/syslog.conf
   *.err;kern.debug;daemon.notice;mail.crit        /var/adm/messages
   *.alert;kern.err;daemon.err                     operator

2. Open the /etc/syslog.conf file for editing and change daemon.notice to daemon.debug.

   The following example output shows that daemon.debug is set.

   phys-schost-N# grep daemon /etc/syslog.conf
   *.err;kern.debug;daemon.debug;mail.crit        /var/adm/messages
   *.alert;kern.err;daemon.err                    operator

3. Restart the syslog daemon.

   phys-schost-N# svcadm restart system-log

4. On each cluster node that has Samba or winbind components that require debug output, enable debugging.

   Edit the /opt/SUNWscsmb/instance/config file and set DEBUG= to either DEBUG=ALL or DEBUG=resource.

   instance

   The samba or winbind subdirectory.

   ALL

   Enables debugging for all resources of the Samba or winbind component.

   resource

   Enables debugging only for the specified resource.

   The following example output shows a Samba configuration file with DEBUG set to ALL, to enable debugging on all Samba resources.

   phys-schost-N# cat /opt/SUNWscsmb/samba/etc/config
   #
   # Copyright 2006 Sun Microsystems, Inc.  All rights reserved.
   # Use is subject to license terms.
   #
   #ident   "@(#)config 1.1     06/03/21 SMI"
   #
   # Usage:
   #       DEBUG=<RESOURCE_NAME> or ALL
   #
   DEBUG=ALL

Next Steps

To turn off debugging, reverse the steps in the previous procedure.