How to Configure Storage Resources for HA for WebLogic Server (clsetup)

These instructions assume that you are at the WebLogic Server Configuration list of options for configuring Oracle Solaris Cluster HA for WebLogic Server in the clsetup utility.

Before You Begin

You must complete How to Configure Logical Host Resources for HA for WebLogic Server (clsetup) before configuring storage resources.

1. In the WebLogic Server Configuration panel, type the number corresponding to Storage and press Return.

   The clsetup utility reminds you that before you continue, you must ensure that the required volumes, disk groups, and file systems were already created.

2. Press Return to continue with configuring highly available storage.

   The clsetup utility displays the available nodes in the cluster, and shows all the nodes as selected in an arbitrary order. You can specify particular nodes in any order of preference.

3. Select the nodes where you want HA for WebLogic Server to run.
   • To accept the default selection of all listed nodes in an arbitrary order, type a and press Return.
   • To select a subset of the listed nodes, type the numbers of the nodes with a space or comma between the numbers and press Return.

     Ensure that the nodes are listed in the order in which the nodes are to appear in the resource group's node list. The first node in the list is the primary node of this resource group.

   • To select all nodes in a particular order, type the numbers of the nodes in the order you want, with a space or comma between the numbers. Then press Return.

     Ensure that the nodes are listed in the order in which the nodes are to appear in the resource group's node list.

4. Type d and press Return when you are done specifying the nodes.
5. Type the number for the type of shared storage you want to configure.

   If you are not sure whether to use a shared file system or shared device, type ? and press Return for information about the storage options.

   After you make a selection, the utility discovers existing file system mount points or storage devices and displays them for you to select.

6. Type the number of the shared file system mount point or shared device and press Return.

   If you are not sure whether to use a shared file system or shared device, type ? and press Return for information about the storage options.

7. In the review panel, do one of the following:
   • To confirm creation of the resources and groups, type d and press Return.
   • To change the names of any resources or groups, type the number of the item in the list and press Return.

     The clsetup utility displays a new panel for changing the names. You can type the number for the name you want to change, and the utility prompts you to change the name.

     Type d and press Return to confirm the new names.

   The utility displays the Review Configuration of Highly Available Storage Resources panel to display the resource name, resource group name, node list, file system mount points, and storage device groups that will be created.

8. To create the configuration, type c and Press Return.

   The clsetup utility displays a progress message to indicate that the utility is running commands to create the configuration. When configuration is complete, the clsetup utility displays the commands that the utility ran to create the configuration.

   ---

   Note - The clsetup utility will roll back the changes if it fails to complete the storage configuration process.

   ---

9. Press Return to continue.

   The clsetup utility returns you to the list of options for configuring HA for WebLogic Server.

   Continue to How to Register and Configure the HA for WebLogic Server as an Administration Server (clsetup).