This section provides information about resynchronizing partnership information between partner clusters.
If a cluster that is a member of a partnership fails, when the cluster restarts, it detects whether the partnership parameters have been modified while it was down. You decide which partnership configuration information you want to keep: the information on the cluster that failed or the information on the failover cluster. Then, resynchronize the configuration of the partnership accordingly.
Use the geoadm status command or Oracle Solaris Cluster Manager to check whether you need to resynchronize a partnership.
If the Configuration status is Synchronization Status Error, you need to synchronize the partnership.
If the Local status is Partnership Error, do not resynchronize the partnership. Instead, wait until a heartbeat exchange occurs.
Perform this procedure to resynchronize partnership configuration information.
Before You Begin
Ensure that the following conditions are met:
The local cluster is Geographic Edition enabled.
The local cluster was an active member of the partnership before failing.
You must be assigned the Geo Management rights profile to complete this procedure. For more information, see Securing Geographic Edition Software in Oracle Solaris Cluster 4.3 Geographic Edition Installation and Configuration Guide.
Caution - Resynchronizing a partnership overwrites the partnership configuration on the cluster where the command is run with the information from the partner cluster. |
# geops update partnership-name
Specifies the name of the partnership
This example resynchronizes the paris-newyork-ps partnership.
# geops update paris-newyork-ps