Rebooting to Use Domains - Oracle® VM Server for SPARC 3.4 Administration Guide

Go to main content

Oracle^® VM Server for SPARC 3.4 Administration Guide

Exit Print View

» ...Documentation Home » Oracle VM Server for SPARC 3.4 Documentation » Oracle^® VM Server for SPARC 3.4 ... » Setting Up Services and the Control Domain » Rebooting to Use Domains

Updated: August 2016

Oracle^® VM Server for SPARC 3.4 Administration Guide

Document Information

Using This Documentation

Chapter 1 Overview of the Oracle VM Server for SPARC Software

Chapter 2 Oracle VM Server for SPARC Security

Chapter 3 Setting Up Services and the Control Domain

Output Messages

Creating Default Services

How to Create Default Services

Initial Configuration of the Control Domain

Configuring the Control Domain

Decreasing the CPU and Memory Resources From the Control Domain's Initial factory-default Configuration

Rebooting to Use Domains

Enabling Networking Between the Oracle Solaris 10 Service Domain and Other Domains

How to Configure the Virtual Switch as the Primary Interface

Enabling the Virtual Network Terminal Server Daemon

How to Enable the Virtual Network Terminal Server Daemon

Verifying That the ILOM Interconnect Is Enabled

How to Verify the ILOM Interconnect Configuration

How to Re-Enable the ILOM Interconnect Service

Chapter 4 Setting Up Guest Domains

Chapter 5 Using Domain Consoles

Chapter 6 Configuring I/O Domains

Chapter 7 Creating a Root Domain by Assigning PCIe Buses

Chapter 8 Creating an I/O Domain by Using PCIe SR-IOV Virtual Functions

Chapter 9 Creating an I/O Domain by Using Direct I/O

Chapter 10 Using Non-primary Root Domains

Chapter 11 Using Virtual Disks

Chapter 12 Using Virtual SCSI Host Bus Adapters

Chapter 13 Using Virtual Networks

Chapter 14 Migrating Domains

Chapter 15 Managing Resources

Chapter 16 Managing Domain Configurations

Chapter 17 Handling Hardware Errors

Chapter 18 Performing Other Administration Tasks

Appendix A Using Power Management

Language:

Rebooting to Use Domains

You must reboot the control domain for the configuration changes to take effect and for the resources to be released for other logical domains to use.

How to Reboot

Shut down and reboot the control domain.
```
primary# shutdown -y -g0 -i6
```
Note - Either a reboot or power cycle instantiates the new configuration. Only a power cycle actually boots the configuration saved to the service processor (SP), which is then reflected in the list-config output.

Copyright © 2007, 2016, Oracle and/or its affiliates. All rights reserved.