Siebel Installation Guide for Microsoft Windows: Servers, Mobile Web Clients, Tools > Installing in Unattended and Console Modes > Installing in Console Mode >

Editing siebel.ini Files for Console Mode Installation

Before starting the installation, you must disable portions of the siebel.ini file.

After you finish the installation, launch the Siebel Software Configuration Wizard through the icons created in your Start menu by the installer. For instructions on how to launch the Configuration Wizard, see Launching the Siebel Software Configuration Wizard.

To modify siebel.ini files for console mode installation

1. Using a text editor, modify the appropriate siebel.ini file or files as listed below:

   NOTE:  Make a copy of each siebel.ini file you plan to modify, and save it in a unique location that identifies the module it pertains to. Preserve these copies in case you may need them for later reference.

   • Siebel Enterprise Server. Windows\Server\Siebel_Enterprise_Server\siebel.ini.
   • Siebel Web Server Extension. Windows\Server\Siebel_Web_Server_Extension\siebel.ini.

     CAUTION:  When you modify a siebel.ini file, make sure that you enter the correct values, because your entries are not validated by the installer.

2. Locate the [RunAfter.Windows] or [RunAfter] section, depending on which .ini file you are modifying, and change the values for the following parameters:
   • Siebel Enterprise Server

   ConfigGateway = no

   ConfigServer = no

   • Siebel Web Server Extension

   Config.SWSE.Windows = no