The installation of the Configuration Change Console and its components must be executed in the order listed below:
Oracle database installation and configuration
Configuration Change Console Server non-clustered or clustered installation and configuration
Configuration Change Console Agent installation
Refer to the Configuration Change Console Database Installation chapters and Configuration Change Console Server Installation chapters for information on how to install the database and server.
The following section provides information on system requirements for all platforms.
The following table depicts the minimum hardware requirements for each supported platform:
| Operating System | Available Hard Drive Space | Total System Memory |
|---|---|---|
|
Microsoft Windows (XP, 2000, 2003 and NT4.0) |
150 MB |
512 MB |
|
Linux (Oracle Enterprise Linux 4, 5, Red Hat V3, V4, 7.3) x86 32 Bit and 64 Bit |
150 MB |
512 MB |
|
HP-UX 11.23 PA-RISC and Itanium 64-bit |
250 MB |
512 MB |
|
IBM AIX 5.3 |
250 MB |
512 MB |
|
Sun Solaris 8, 9, 10 |
250 MB |
512 MB |
|
OS/400 V5R4 |
250 MB |
512 MB |
The values in the table are minimum requirements; settings may depend on your environment.
The following items are prerequisites for all platforms:
Service Pack and Patch. Please review the prerequisites for each supported platform to ensure that the most recent service pack or patch is installed. Additionally, each supported platform may have prerequisites specific to that system. These platform specific prerequisites are documented in their respective sections.
Configuration Change Console Primary and Messaging Broker Servers' IP and HTTPS ports. Obtain the IP and the HTTPS (443 by default) port that was set during server installation. This information is used to specify how the agents will communicate with the server(s).
Administrator role account on Primary Server: When installing the agent, you must authenticate with the server. To do this, the installer will prompt you for an administrator role user name and password on the server. If you do not have an account, you must get one from the Configuration Change Console administrator first.