WebLogic Exchange Service Setup
|
 |
 |
|
 |
 |
This guide is intended for Microsoft Exchange administrators who need to install the WebLogic Exchange Service.
Note: Use of the WebLogic Exchange Service supports connecting to Microsoft Exchange 5.5, 2000 and 2003 and is used with the Exchange/MAPI Provider. If you are running Microsoft Exchange 2000 or 2003, you can use the Exchange/WebDAV Provider for connectivity to Exchange; therefore, the WebLogic Exchange Service is not required to be installed.
Refer to the BEA WebLogic Personal Messaging API Administration Guide for more information on the differences between the Exchange/MAPI Provider and Exchange/WebDAV Provider.
This chapter contains the following sections:
Before you install the WebLogic Exchange Service, perform the following steps:
- The MAPI subsystem must be installed on the WebLogic Exchange Service machine. For more information, see Installing the MAPI Subsystem.
- Refer to the BEA WebLogic Personal Messaging API Supported Configurations Guide for more information on specific platform and OS combinations.
The Windows convention of "\" as a path separator is used wherever necessary.
Also, since system software and configurations can vary from one system to another, portions of the command syntax displayed in this document may include sample parameters or variables that represent the actual command syntax you would need to enter. These entries are indicated by parameters in uppercase placed between percent signs (%PARAMETER%), as shown in the following table.
