Bookshelf Home | Contents | Index | PDF |
Siebel Assignment Manager Administration Guide > Siebel Assignment Manager Load Splitter Configuration > Setting Up Load Splitter ConfigurationTo set up load splitter configuration for Siebel Assignment Manager, the assignment administrator specifies a list of servers, the number of tasks each of those servers can run, and the priority for each server for a given configuration. Use the following procedure to set up load splitter configuration for your needs. NOTE: Make sure the Assignment Manager server component is enabled on all the specified servers. For more information about checking the status of this component, see Checking the State of Siebel Assignment Manager and Server Request Broker Components. To set up load splitter configuration
TIP: It is recommended to set your first priority number fairly high, such as to 100, and to provide sufficient gaps between priority numbers. Doing this can be helpful in case new servers are added for processing load splitting tasks, because you will not need to reset your entire priority arrangement. For example, if you start with two servers, set one priority at 100, and the other at 200. Then, if you add a third server, you could set its priority to 150 if its priority should be between that of the other two values.
Figure 40 shows a sample Align configuration that uses two servers, Server A and Server B, to process multiple tasks. In this configuration, Server A has a higher priority than Server B. |
Siebel Assignment Manager Administration Guide | Copyright © 2013, Oracle and/or its affiliates. All rights reserved. Legal Notices. | |