At the time of manufacturing in the factory, an Exalogic machine has the following network topology:
Compute nodes configured with NET0
, ILOM
, and BOND0
interfaces
Note:
Exalogic compute nodes are not pre-configured with the BOND1
interface for the Ethernet over InfiniBand (EoIB) connectivity. You can configure BOND1
for compute notes during the initial configuration of the Exalogic machine.
Storage heads configured with NET0
, ILOM
, and BOND0
interfaces
Sun Network QDR InfiniBand Gateway Switches, referred to as leaf switches, configured with the ILOM
interface
Sun Datacenter InfiniBand Switch 36, referred to as the spine switch, not configured
Note:
This switch is used in multirack configuration scenarios only.
Cisco Ethernet Management Switch, which is not configured