2. Getting Started With Solaris Smartcard
3. Adding or Removing a Card Reader
Resolving Smartcard Login Problems
To Correct Smartcard Setup Problem
Resolving Applet, ATR, or Configuration Problems
Resolving Applet Downloading Problems
You can debug smart-card operations on a system by setting the debugging properties. Solaris Smartcard offers standard debugging and a detailed trace of your operations, if specified. If enabled, debugging information is logged to a file. You can control the level and amount of debugging information on a 0–9 scale. Debugging is disabled by default.
The following debugging properties are defined for ocfserv by default:
debugging.filename = /var/run/ocf.log debugging = 0
Debugging is disabled. Debugging is enabled if debugging = 1.
Note - Previous to the Solaris 8 release, the debugging log file might be called /tmp/ocf_debugfile.
For debugging procedures, see the following:
The following command provides the status of the service.
% svcs network/rpc/ocfserv
Note - Before you make any changes to Smartcard, you must make sure that the ocfserv daemon is enabled.
# svcadm enable network/rpc/ocfserv
Use the following procedure to enable smart-card debugging.
The following command provides the status of the service.
% svcs network/rpc/ocfserv
Note - Before you make any changes to Smartcard, you must make sure that the ocfserv daemon is enabled.
# svcadm enable network/rpc/ocfserv
# smartcard -c admin -x modify debugging=1
In the following example, the location of the ocfserv debugging file is changed. The location is changed by using the -x modify debugging.filename option and by specifying a fully qualified file name for the debugging file.
# smartcard -c admin -x modify debugging.filename=/var/tmp/sc.debug