|Skip Navigation Links|
|Exit Print View|
|System Administration Guide: Oracle Solaris Containers-Resource Management and Oracle Solaris Zones|
The poolstat utility is used to monitor resource utilization when pools are enabled on your system. This utility iteratively examines all of the active pools on a system and reports statistics based on the selected output mode. The poolstat statistics enable you to determine which resource partitions are heavily utilized. You can analyze these statistics to make decisions about resource reallocation when the system is under pressure for resources.
The poolstat utility includes options that can be used to examine specific pools and report resource set-specific statistics.
If zones are implemented on your system and you use poolstat in a non-global zone, information about the resources associated with the zone's pool is displayed.
For more information about the poolstat utility, see the poolstat(1M) man page. For poolstat task and usage information, see Using poolstat to Report Statistics for Pool-Related Resources.
In default output format, poolstat outputs a heading line and then displays a line for each pool. A pool line begins with the pool ID and the name of the pool, followed by a column of statistical data for the processor set attached to the pool. Resource sets attached to more than one pool are listed multiple times, once for each pool.
The column headings are as follows:
Resource set ID.
Resource set name.
Resource set type.
Minimum resource set size.
Maximum resource set size.
Current resource set size.
Measure of how much of the resource set is currently used.
This usage is calculated as the percentage of utilization of the resource set multiplied by the size of the resource set. If a resource set has been reconfigured during the last sampling interval, this value might be not reported. An unreported value appears as a hyphen (-).
Absolute representation of the load that is put on the resource set.
For more information about this property, see the libpool(3LIB) man page.
You can specify the following in poolstat output:
The order of the columns
The headings that appear
You can customize the operations performed by poolstat. You can set the sampling interval for the report and specify the number of times that statistics are repeated:
Tune the intervals for the periodic operations performed by poolstat. All intervals are specified in seconds.
Specify the number of times that the statistics are repeated. By default, poolstat reports statistics only once.
If interval and count are not specified, statistics are reported once. If interval is specified and count is not specified, then statistics are reported indefinitely.