ChorusOS 4.0 Introduction

Site Number Administration

The IPC feature has the concept of a site number, a 32-bit unsigned integer which uniquely identifies a target board. Applications exchange messages through IPC ports, which are designated by a global identifier which includes the site number of the target board where the port is located.

The site number of a target is sent to the kernel at boot time in one of two ways:

  1. dynamically, by the boot program, which sets the siteNumber field of the bootConf structure before invoking the kernel start entry

  2. statically, by setting the chorusSiteId kernel tunable in the ChorusOS system image built on the host:

    % configurator -set chorusSiteId=n

    n is the site number assigned to the target board. This number can be specified in hexadecimal, by prefixing the number with 0x, or decimal.

When the site number is set dynamically, it is the responsibility of the boot program to determine the site number of the target. The method by which the site number is found by the boot program is fully boot dependent, and specific to the target board. It may, for example, be stored in NVRAM, dynamically generated from a unique board identifier. When the target is booted with the standard ChorusOS network boot monitor, the whole IP address used by the boot monitor is provided as the site number of the target.

When the site number is set statically, the site number is fixed within the system image. This approach is less flexible than the dynamic method because the same system image cannot be booted on similar target boards. A system image with a unique site number must be built for each target. For this reason, it should only be used when there is no way for the boot program to determine the site number of the target board.

Note -

The value of the site number set with the chorusSiteId tunable takes precedence over the value of the site number provided by the boot program.

The site number is set to zero by default. If the IPC_REMOTE feature has been enabled, and the site number remains at zero, the following message is displayed on the system console:


Only local IPC communications are enabled if the site number has not been set.