test

Sun Cluster 3.0 Hardware Guide

How to Install a StorEdge A5x00

Use this procedure to install an StorEdge A5x00 disk array. Perform the steps in this procedure in conjunction with the procedures in Sun Cluster 3.0 Installation Guide and your server hardware manual.

  1. Install host adapters in the nodes that will be connected to the disk array.

    For the procedure on installing host adapters, see the documentation that shipped with your network adapters and nodes.

    Note -

    To ensure maximum redundancy, put each host adapter on a separate I/O board if possible.

  2. Cable, power on, and configure the disk array.

    Figure 6-1 shows a sample disk array configuration.

    For more information on cabling and configuring disk arrays, see Sun StorEdge A5000 Installation and Service Manual.

    Figure 6-1 Sample StorEdge A5x00 Disk Array Configuration

    Graphic

  3. Check the hardware firmware levels, and install any required firmware updates.

    For the location of patches and installation instructions, see Sun Cluster 3.0 Release Notes.

Where to Go From Here

To install software, follow the procedures in Sun Cluster 3.0 Installation Guide.